[Free] 2018(Mar) Dumps4cert Pass4sure Cisco 400-051 Dumps with VCE and PDF Download 261-270

Dumps4cert.com : Latest Dumps with PDF and VCE Files 2018 Mar Cisco Official New Released 400-051
100% Free Download! 100% Pass Guaranteed!

CCIE Collaboration (v1.1)

Question No: 261 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

Which option describes the security encryption status of this active call on a Cisco IP phone?

  1. Encrypted call media but unencrypted call signalling

  2. Encrypted call signalling and media

  3. Encrypted call signalling but unencrypted call media

  4. Unencrypted call signalling and media

  5. Not enough information provided to answer this QUESTION NO:

Answer: C

Question No: 262 – (Topic 1)

A cisco Unified CM user is set up with one remote destination profile that has two remote destination numbers.

First destination number is the user#39;s mobile phone in country A and the Second is a mobile phone located in country B. All outbound calls are centralized from the gateway at country A. The user reports that inbound calls are properly routed to the mobile phone as long as the user is in country A. but inbound calls are not successfully routed to country B?

What could resolve this issue? (Choose two)

  1. The enable mobile connect option must be selected under the user#39;s second remote destination number

  2. The value of remote destination limits should be change to 2 instead of the default value of 4 under the end user page

  3. The enable mobile voice access option must be selected under the end user page

  4. The value of maximum wait time for desk pickup should be change 20000 instead of the default of 10000, under the end user page

  5. The rerouting calling search space assigned to the user#39;s remote destination profile must have access to international calls

Answer: A,E

Question No: 263 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

A customer has two Cisco Unified Communication manager 9.X clusters that serve the same location. An engineer has attempted to set up Enhanced Location call admission control so that any call within a site between phones on the two clusters do not decrement the available bandwidth to and from that site. However, the real time monitoring tool currently shows bandwidth being used from the site to Hub_none. When a call is placed between phones at the site, which action must be taken to correct this situation?

  1. The link between clusters must be a type of inter-cluster trunk instead of a sip trunk.

  2. The hub_none location must have a link configuration to the phantom location.

  3. The device pool names must match between clusters.

  4. The Hub_none location must have a link configured to the shadow location.

  5. The SIP trunks should be changed to use the shadow location.

Answer: E

Question No: 264 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

Cisco VoIP administrator is configuring CUE VoiceView Express for end users and they are not able to manage their voice message from the Cisco IP phone. Which two configuration commands are required? (Choose two).

  1. url information

  2. url services

  3. url authentication

  4. url messages http;//

  5. url services

Answer: B,C

Question No: 265 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

The exhibit shows an outgoing SIP 401 response message from Cisco Unified

Communications Manager to a SIP VoIP service provider gateway. Which action can the Cisco Unified

Communication Manager Systems administrator use to change the response to quot;200 OKquot;?

  1. Disable OPTIONS ping on Cisco Unified Communications manager sip trunk,

  2. Create an SIP response alias to force outgoing 401 messages to quot;200 OKquot;

  3. Make sure the gateway IP address of the SIP VoIP service provider is defined correctly in Cisco Unified

    Communications Manager SIP trunk

  4. Enable OPTIONS ping on Cisco Unified Communications Manager SIP trunk

  5. Disable digest authentication on Cisco Unified Communications Manager SIP trunk.

Answer: E

Question No: 266 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

A VoIP engineer must configure QoS for the switch ports. Which two set of commands configure switch port to remap every incoming packet aside from the default QoS? (Choose two).

  1. FastEthernet 0/20

    No mls qos trust device cisco-phone

  2. FastEthernet 0/20 No mls qos trust cos

  3. FastEthernet 0/20 mls qos cos 3

  4. FastEthernet 0/20 Mls qos cos override

  5. FastEthernet 0/20

    No switchport priority extend trust

  6. FastEthernet 0/20 Switchport priority extend cos

Answer: C,D

Question No: 267 – (Topic 1)

You want your SDN controller to build a topology map of your network. Which protocol can be used to export IGP information from the network to the SDN controller?

  1. VXLAN

  2. JSON

  3. BGP- LS

  4. OpenFlow

  5. PCEP

Answer: C

Question No: 268 – (Topic 1)

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

A voicemail administrator was asked to create a call handler for the sales department with the following requirements,

  • No end date for any of the configured greetings

  • Play a specific greeting on business-approved days off

  • Play a specific greeting when a sales agent calls the call handler number

  • After creating the call handler and making some test calls only the default system greeting is heard

Which four configuration changes are needed to company with this business request? (Choose Four)

  1. Disable the Alternate Greeting under Call Handler Greetings

  2. Create a new closed schedule and assign it to the sales Call Handler

  3. Record a new Greeting and assign it to the Alternate Greeting

  4. Record a new Greeting and assign it to the Holiday Greeting

  5. Record a new Greeting and assign it to the Internal Greeting

  6. Create a new holiday schedule to be used by the Holiday Greeting

  7. Disable the Internal Greeting under Call Handler Greeting

  8. Enable the Closed Greeting under Call Handler Greetings

Answer: A,D,F,G

Question No: 269 – (Topic 1)

Which two components are required when configuring the Cisco Unified Communications Manager for time-of-day routing? (Choose three.)

  1. Partition

  2. Time Period

  3. Time Schedule

  4. Time Zone

  5. Date Time Group

Answer: A,B,C

Question No: 270 – (Topic 1)

Refer to Exhibit:

Dumps4Cert 2018 PDF and VCE

How many SIP signalling transaction(s) took place in this SIP message exchange between two SIP user


  1. 1

  2. 2

  3. 3

  4. 4

  5. 5

  6. 6

Answer: C

100% Dumps4cert Free Download!
Download Free Demo:400-051 Demo PDF
100% Dumps4cert Free Guaranteed!
400-051 Dumps

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Add a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.